Table of Contents
Advertisement
Input Configuration Menu
The Input Configuration menu allows you to select a video signal type for the
configurable inputs: 5, 6, 7, and 9. (Inputs 1 and 2 are composite video only, inputs 3 and
4 are S-video only, and inputs 8 and 10 are DVI only.) The table below summarizes the
available signal types for each input.
Input 1
Input 2
Composite Composite S-video S-video RGB*
*Default
You can also enable and disable film detection, select the horizontal and vertical start
positions, pixel sampling phase, total pixels, active pixels, active lines, and select an EDID
(extended display identification data) for an input. Rotate the horizontal ( [ ) or the vertical ( { )
ADJUST knob to adjust the settings.
The following flowchart provides an overview of the Input Configuration menu and
submenus and the options for each setting.
User
Presets
Menu
Input
Configuration
Next
Input # 5
Next
RGB
Film Detect: Off
Input video type
Film Detect
For inputs 5, 6, 7, and 9,
Turn Film Detection on
select an available signal
or off.
format:
•
RGB (Default)
•
YUVp/HDTV
•
RGBcvS
•
YUVi
Next
Input # 5 EDID
1280x1024
60 Hz
Resolution
Refresh Rate
Select the input resolution:
Select the rate:
•
•
Match Output (Default)
50 Hz
•
•
See the Resolution and
59.9 Hz
•
Refresh Rate table in the
60 Hz
"Output Configuration Menu"
•
75 Hz
section for a complete list of
available resolutions.
Figure 16.
Input 3 Input 4 Input 5
YUVp/
HDTV
RGBcvS
YUVi
Input # 5
Input # 5
Next
Vert Start: 128
Vertical Start
Select a vertical start
line position for the top
edge of the active video.
Input # 5
Next
Next
Active Lns: 1080
Active Lines
Specify the height in lines
of the active image area to
be sampled.
Input Configuration Menu
Input 6
Input 7
Input 8 Input 9
RGB*
RGB*
DVI
YUVp/
YUVp/
HDTV
HDTV
RGBcvS RGBcvS
YUVi
YUVi
Input # 5
Next
Horz Start: 128
Horizontal Start
Select a horizontal start
pixel position for the left
edge of the active video.
Input # 5
Input # 5
Next
Active Pix: 1920
Total Pix:
Active Pixels
Total Pixels
Specify the width in pixels
Specify the width in pixels
of the total image area to
of the active image area to
be sampled.
be sampled.
DVS 510 Series • Operation
Input 10
RGB*
DVI
YUVp/
HDTV
RGBcvS
YUVi
Input # 5
Next
Pixel Phase: 16
Pixel Phase
Adjust the pixel sampling
point.
Next
2750
23
Advertisement
Table of Contents
