Input Configuration Menu - Extron electronics DVS 510 User Manual

Input Configuration Menu

The Input Configuration menu allows you to select a video signal type for the configurable
inputs: 5, 6, 7, and 9. (Inputs 1 and 2 are composite video only, inputs 3 and 4 are S-video
only, and inputs 8 and 10 are DVI only.) The table below summarizes the available signal
types for each input.
Input 1 Input 2
Composite Composite S-video
*Default
You can also enable and disable film detection; select the horizontal and vertical start
positions, pixel sampling phase, total pixels, active pixels, active lines; and select an EDID
(extended display identification data) for an input. Rotate the horizontal ([) or the
vertical ({) Adjust knob to adjust the settings.
The following flowchart provides an overview of the Input Configuration menu and
submenus and the options for each setting.
User
Presets
Menu
Input
Configuration
Next
Input # 5
Next
RGB Film Detect: Off
Input video type Film Detect
For inputs 5, 6, 7, and 9, Turn Film Detection on
select an available signal or off.
format:
•
RGB (Default)
•
YUVp/HDTV
•
RGBcvS
•
YUVi
Next
Input # 5 EDID
1280x1024 60 Hz
Resolution
Refresh Rate
Select the input resolution:
Select the rate:
• •
Match Output (Default) 50 Hz
•
•
See the Resolution and 59.9 Hz
Refresh Rate table in the •
60 Hz
"Output Configuration Menu"
•
75 Hz
section for a complete list of
available resolutions.
Figure 15.
Input 3 Input 4 Input 5
S-video RGB*
YUVp/
HDTV
RGBcvS
YUVi
Input # 5
Input # 5
Next
Vert Start: 128
Vertical Start
Select a vertical start
line position for the top
edge of the active video.
Input # 5
Next Next
Active Lns: 1080
Active Lines
Specify the height in lines
of the active image area to
be sampled.
Input Configuration Menu
Input 6 Input 7 Input 8
RGB* RGB* DVI
YUVp/ YUVp/
HDTV HDTV
RGBcvS RGBcvS
YUVi YUVi
Input # 5
Next
Horz Start: 128
Horizontal Start
Select a horizontal start
pixel position for the left
edge of the active video.
Input # 5 Input # 5
Next
Active Pix: 1920 Total Pix:
Total Pixels
Active Pixels
Specify the width in pixels Specify the width in pixels
of the active image area to of the total image area to
be sampled. be sampled.
DVS 510 Series • Operation
Input 9 Input 10
RGB* DVI
YUVp/
HDTV
RGBcvS
YUVi
Input # 5
Next
Pixel Phase: 16
Pixel Phase
Adjust the pixel sampling
point.
Next
2750
23