Status Displays; General Status Display - HEIDENHAIN TNC 320 User Manual

2
Introduction
2.4

Status displays

2.4 Status displays

General status display

The general status display in the lower part of the screen informs
you of the current state of the machine.
It is displayed automatically in the following operating modes:
Program run, single block
Program run, full sequence
Positioning with manl.data input
If the GRAPHICS screen layout is selected the status
display is not shown.
In the Manual operation and Electronic handwheel modes the
status display appears in the large window.
Information in the status display
Icon Meaning
ACTL. Position display: Actual, nominal or distance-to-go
coordinates mode
Machine axes; the TNC displays auxiliary axes in
lower-case letters. The sequence and quantity of
displayed axes is determined by the machine tool
builder. Refer to your machine manual for more
information
Number of the active presets from the preset
table. If the datum was set manually, the TNC
displays the text MAN behind the symbol
F S M The displayed feed rate in inches corresponds to
one tenth of the effective value. Spindle speed S,
feed rate F and active M functions
Axis is clamped
Axis can be moved with the handwheel
Axes are moving under a basic rotation
Axes are moving under a 3-D basic rotation
Axes are moving in a tilted working plane
80
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016