Starting The Test Run - HEIDENHAIN TNC 320 User Manual

1
First Steps with the TNC 320
1.4 Graphically testing the first part

Starting the test run

Press the RESET + START soft key
The control resets the previously active tool data
The control simulates the active program up to a
programmed break or to the program end
While the simulation is running, you can use the
soft keys to change views
Press the STOP soft key
The TNC interrupts the test run
Press the START soft key
The control resumes the test run after a break
Further information on this topic
Performing a test run
Further Information:
Graphic functions
Further Information:
Adjusting the simulation speed
Further Information:
page 545
66
"Test run", page 556
"Graphics ", page 544
"Speed of the setting test runs",
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016