HEIDENHAIN TNC 320 User Manual page 534

13
Manual Operation and Setup
13.10 Tilting the working plane (option 8)
The control uses the following
for tilting:
COORD ROT
TABLE ROT
To deactivate manual tilting
To deactivate, set the appropriate operating modes to Inactive in
the Tilt working plane menu.
Even if the 3D-ROT dialog in the Manual operation mode is set
to Active, resetting the tilting (PLANE RESET) with an active basic
transformation still functions correctly.
534
transformation types
if a PLANE function was previously executed
with COORD ROT
after PLANE RESET
with corresponding configuration
of the machine parameter
CfgRotWorkPlane(no. 201200) by the machine
tool builder
after starting the control
after switching the kinematics
after running the cycle 19 WORKING PLANE
if a PLANE function was previously executed
with TABLE ROT
with corresponding configuration
of the machine parameter
CfgRotWorkPlane(no. 201200) by the machine
tool builder
after starting the control
after switching the kinematics
after running the cycle 19 WORKING PLANE
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016