HEIDENHAIN TNC 320 User Manual page 664

17
Tables and Overviews
17.5 Functions of the TNC 320 and the iTNC 530 compared
Function
PLANE function:
TABLE ROT/COORD ROT
Machine is configured for axis
angle
Programming an incremental
spatial angle according to
PLANE AXIAL
Programming an incremental
axis angle according to PLANE
SPATIAL if the machine is
configured for spatial angle
Programming of PLANE
functions with active Cycle 8
MIRRORING
Special functions for cycle
programming:
FN17
FN18
Compensation of tool length in the
position display
664
TNC 320
Effect:
The transformation types are
effective on all free rotary axes
The control does not always
position the free rotary
axis with TABLE ROT, but
depending on the current
position, the programmed
spatial angle and the machine
kinematics
Default with missing selection:
COORD ROT is used
All PLANE functions can be
used
Error message is issued
Error message is issued
Mirroring has no influence on
tilting using AXIAL PLANE and
Cycle 19
Function available
Values are always output in
metric form
Further details are different
Function available
Values are always output in
metric form
Details are different
The tool length entries L and DL
from the tool table are taken into
account in the position display,
from TOOL CALL block depending
on the machine parameter
progToolCallDL(no. 124501)
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016
iTNC 530
Effect
The transformation types are
only effective with a C rotary
axis
With TABLE ROT the control
always positions the rotary axis
Default with missing selection:
COORD ROT is used
Only PLANE AXIAL is executed
Incremental spatial angle is
interpreted as an absolute
value
Incremental axis angle is
interpreted as an absolute
value
Function is available with all
PLANE functions
Function available
Values are output in the units
of the active NC program
Details are different
Function available
Values are output in the units
of the active NC program
Details are different
The tool length entries L and DL
from the tool table are taken into
account in the position display