HEIDENHAIN TNC 320 User Manual page 44

Contents
12 Multiple axismachining................................................................................................................443
12.1 Functions for multiple axis machining............................................................................................. 444
12.2 The PLANE function: Tilting the working plane (software option 8)............................................. 445
Introduction........................................................................................................................................... 445
Overview............................................................................................................................................... 446
Defining the PLANE function................................................................................................................447
Position display......................................................................................................................................447
Resetting PLANE function.................................................................................................................... 448
Defining the working plane with the spatial angle: PLANE SPATIAL....................................................449
Defining the working plane with the projection angle: PLANE PROJECTED....................................... 450
Defining the working plane with the Euler angle: PLANE EULER........................................................452
Defining the working plane with two vectors: PLANE VECTOR.......................................................... 454
Defining the working plane via three points: PLANE POINTS..............................................................456
Defining the working plane via a single incremental spatial angle: PLANE RELATIV........................... 458
Tilting the working plane through axis angle: PLANE AXIAL................................................................459
Specifying the positioning behavior of the PLANE function.................................................................461
Tilt the working plane without rotary axes...........................................................................................468
12.3 Miscellaneous functions for rotary axes.......................................................................................... 469
Feed rate in mm/min on rotary axes A, B, C: M116 (option 8).............................................................469
Shortest-path traverse of rotary axes: M126........................................................................................470
Reducing display of a rotary axis to a value less than 360°: M94........................................................471
Selecting tilting axes: M138................................................................................................................. 472
44
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016