HEIDENHAIN TNC 320 User Manual page 23

Compact contouring control

Hide thumbs Also See for TNC 320:

Table of Contents

New and modified cycle functions 77185x-04

New cycle 258 POLYGON STUD

Cycles 421, 422 and 427 were expanded by the parameters

Q498 and Q531

For cycle 247: SET DATUM, the datum number from the preset

table can be selected with the corresponding parameter

With cycle 200 and 203 the behavior of the dwell time at top

has been adapted

Cycle 205 performs deburring on the coordinate surface

With SL cycles, M110 is now taken into account with circles

compensated inwards if it is active during machining

With Cycle 251 Rectangular pocket, M110 is now taken into

account with circles compensated inwards if it is active during

Cycle 225 has been expanded with parameters Q516, Q367 and

Q574. This enables a datum for the specific text position to be

defined or the text length and character height to be scaled

In cycles 481 to 483 the parameter Q340 was expanded with

the input option "2". This enables a tool control without making

any change in the tool table

Cycle 251 has been expanded by parameter Q439. The finishing

strategy was also revised

The finishing strategy was revised with cycle 252

Cycle 275 has been expanded with parameters Q369 and Q439

Further information:

Cycle Programing User's Manual

HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016

TNC model, software and features