HEIDENHAIN TNC 320 User Manual page 84

2
Introduction
2.4 Status displays
Program section repeat/Subprograms (LBL tab)
Soft key Meaning
No direct Active program section repeats with block
selection number, label number, and number of
possible programmed repeats/repeats yet to be run
Active subprograms with block number in
which the subprogram was called and the label
number that was called
Information on standard cycles (CYC tab)
Soft key Meaning
No direct Active fixed cycle
selection
possible
Active values of Cycle 32 Tolerance
84
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016