HEIDENHAIN TNC 320 User Manual page 11

Compact contouring control

Hide thumbs Also See for TNC 320:

Table of Contents

TNC model, software and features

Changed functions 34055x-06

The maximum number of characters for the NAME and DOC

fields in the tool table has been increased from 16 to 32, see

"Enter tool data into the table", page 188

Operation and positioning behavior of the manual probing cycles

has been improved, see "Using a 3-D touch probe ", page 501

Predefined values can now be entered into a cycle

parameter with the PREDEF function in cycles,

see Cycle Programming User's Manual

With the KinematicsOpt cycles a new optimization algorithm is

now used, see the Cycle Programming User's Manual

With Cycle 257 , CIRCULAR STUD, a parameter is now available

with which you can determine the approach position on the

stud, see User's Manual for Cycle Programming

With Cycle 256 RECTANGULAR STUD, a parameter is now

available with which you can determine the approach position on

the stud, see Cycle Programming User's Manual

With the manual "Basic Rotation" touch probe cycle, workpiece

misalignment can now be compensated for with a table

rotation, see "Compensation of workpiece misalignment by

rotating the table", page 518

HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016