HEIDENHAIN TNC 320 User Manual page 19

TNC model, software and features
In Test run operating mode the soft keyFMAX PATHS hides
the rapid traverse movements, see "3-D view in the Test Run
operating mode", page 548
In Test run operating mode the soft keyRESET THE VOLUME
MODEL resets the solid model, see "3-D view in the Test Run
operating mode", page 548
In Test run operating mode the soft keyRESET TOOL PATHS
resets the tool paths, see "3-D view in the Test Run operating
mode", page 548
In Test run operating mode the soft key MEASURING displays
the coordinates if you position the mouse on the graphics, see
"3-D view in the Test Run operating mode", page 548
In Test run operating mode the soft key STOP AT simulates
up to a predefined block, see "Test run up to a certain block ",
page 559
Active basic transformation is shown in the status display on the
POS tab, see "Positions and coordinates (POS tab)", page 85
The status display now also shows the path of the active main
program, see "Overview", page 83, see "General program
information (PGM tab)", page 83
In the status display the CYC tab now also shows T-Max and
TA-Max
Mid-program startup can now be continued, see "Any entry into
program: Mid-program startup", page 569
With functions NC/PLC Backup and NC/PLC Restore you can
save and restore single directories or the complete TNC drive,
see "Backup and restore", page 97
19
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016