HEIDENHAIN TNC 320 User Manual page 304

8
Subprograms and program section repeats
8.4 Any desired program as subprogram
Call with SEL PGM and CALL SELECTED PGM
Use the function SEL PGM to select any program as a subprogram
and call it at another position in the program. The control runs
the called program from the position where it was called in the
program with CALL SELECTED PGM.
The SEL PGM function is also permitted with string parameters, so
that you can dynamically control program calls.
To select the program, proceed as follows:
To select the functions for program call, press the
PGM CALL key
Press the SELECT PROGRAM soft key: The TNC
starts the dialog for defining the program to be
called
Press the SELECT FILE soft key: The TNC displays
a selection window in which you can select the
program to be called; confirm with theENT key
To call the selected program, proceed as follows:
To select the functions for program call, press the
PGM CALL key
Press the CALL SELECTED PROGRAM soft key:
The TNC calls the last program selected with CALL
SELECTED PGM
304
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016