HEIDENHAIN TNC 320 User Manual page 237

Approaching on a circular path with tangential
connection from a straight line to the contour:
APPR LCT
The tool moves on a straight line from the starting point P
an auxiliary point P . It then moves to the first contour point P
H
on a circular arc. The feed rate programmed in the APPR block is
effective for the entire path that the TNC traversed in the approach
block (path P to P ).
S A
If you have programmed the coordinates of all three principal axes
X, Y and Z in the approach block, the TNC moves the tool from the
position defined before the APPR block to the auxiliary point P
all three axes simultaneously. Then the TNC goes from P
only on the working plane.
The arc is connected tangentially both to the line P
as to the first contour element. Once these lines are known, the
radius then suffices to completely define the tool path.
Please note that earlier programs may need to be
adapted.
The arc is connected tangentially both to the line P
as to the first contour element. Once these lines are known, the
radius then suffices to completely define the tool path.
Use any path function to approach the starting point P
Initiate the dialog with the APPR DEP key and APPR LCT soft
key:
Coordinates of the first contour point P
Radius R of the circular arc. Enter R as a positive
value
Radius compensation RR/RL for machining
Example NC blocks
7 L X+40 Y+10 R0 FMAX M3
8 APPR LCT X+10 Y+20 Z-10 R10 RR F100
9 L X+20 Y+35
10 L ...
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016
Approaching and departing a contour
to
S
A
on
H
to P
H A
- P as well
S H
–P as well
S H
.
S
A
Approach PS without radius compensation
PA with radius compensation RR, radius R=10
End point of the first contour element
Next contour element
6
6.3
237