HEIDENHAIN TNC 320 User Manual page 574

15
Test Run and Program Run
15.6 Automatic program start
15.6 Automatic program start
Application
The TNC must be specially prepared by the machine
tool builder for use of the automatic program start
function. Refer to your machine manual.
Caution: Danger for the operator!
The autostart function must not be used on
machines that do not have an enclosed working
space.
In a Program Run operating mode, you can use the AUTOSTART
soft key to define a specific time at which the program that is
currently active in this operating mode is to be started:
Display window for setting the starting time
Time (hrs:min:sec): Time of day at which the
program is to be started
Date (DD.MM.YYYY): Date on which the program
is to be started
To activate the start, press the OK
574
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016