HEIDENHAIN TNC 320 User Manual page 122

3
Fundamentals, file management
3.2 Opening programs and entering
Possible feed rate input
Soft key Functions for setting the feed rate
Rapid traverse, blockwise. Exception: If defined
before an APPR block, FMAX also in effect for
moving to an auxiliary point
Further Information:
approach and departure", page 233
Traverse feed rate automatically calculated in
TOOL CALL
Move at the programmed feed rate (unit of
measure is mm/min or 1/10 inch/min). With
rotary axes, the TNC interprets the feed rate
in degrees/min, regardless of whether the
program is written in mm or inches
Define the feed per revolution (units in mm/1
or inch/1). Caution: In inch-programs, FU cannot
be combined with M136
Define the tooth feed (units in mm/tooth or
inch/tooth). The number of teeth must be
defined in the tool table in the CUT column.
Key Functions for conversational guidance
Ignore the dialog question
NO
ENT
End the dialog immediately
Abort the dialog and erase the block
122
"Important positions for
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016