HEIDENHAIN TNC 320 User Manual page 86

2
Introduction
2.4 Status displays
Information on tools (TOOL tab)
Soft key Meaning
Display of active tool:
T: Tool number and tool name
RT: Number and name of a replacement tool
Tool axis
Tool length and tool radii
Oversizes (delta values) from the tool table (TAB)
and the TOOL CALL (PGM)
Tool life, maximum tool life (TIME 1) and maximum
tool life for TOOL CALL (TIME 2)
Display of programmed tool and replacement tool
Tool measurement (TT tab)
The TNC displays the TT tab only if the function is
active on your machine.
Soft key Meaning
No direct Active tool
selection
possible
Measured values from tool measurement
86
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016