HEIDENHAIN TNC 320 User Manual page 576

15
Test Run and Program Run
15.8 Optional program-run interruption
15.8 Optional program-run interruption
Application
Refer to your machine manual.
The behavior of this function varies depending on the
respective machine.
The TNC optionally interrupts program run at blocks containing M1.
If you use M1 in the Program run mode, the TNC does not switch
off the spindle or coolant.
Do not interrupt Program run or Test run with
blocks containing M1: Set the soft key to OFF
Interrupt Program run or Test run with blocks
containing M1: Set the soft key to ON
576
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016