Graphically Testing The First Part; Selecting The Correct Operating Mode; Selecting The Tool Table For The Test Run - HEIDENHAIN TNC 320 User Manual

1
First Steps with the TNC 320
1.4

Graphically testing the first part

1.4 Graphically testing the first part

Selecting the correct operating mode

You can test programs in the Test run mode:
Press the operating mode key for the TNC to
switch to Test Run operating modeTest run
Further information on this topic
Operating modes of the TNC
Further Information:
Testing programs
Further Information:

Selecting the tool table for the test run

If you have not yet activated a tool table in Test run mode, then
you must carry out this step.
Press the PGM MGT key: The TNC opens the file
manager
Press the SELECT TYPE soft key: The TNC shows
a soft-key menu for selection of the file type to be
displayed
Press the DEFAULT soft key: The TNC shows all
saved files in the right-hand window
Move the cursor to the left onto the directories
Move the cursor to the TNC:\table directory
Move the cursor to the right onto the files
Move the cursor onto the file TOOL.T (active tool
table), confirm with the ENT key: TOOL.T contains
the status S and is therefore active for the test run
Press the END key: Exit the file manager
Further information on this topic
Tool management
Further Information:
page 188
Testing programs
Further Information:
64
"Modes of operation", page 77
"Test run", page 556
"Enter tool data into the table",
"Test run", page 556
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016