HEIDENHAIN TNC 320 User Manual page 575

15.7 Optional block skip
Application
Blocks that you mark with a "/" sign may be skipped in Test run or
Program Run, Full Sequence/Single Block:
To run or test the program without the NC blocks
preceded by a slash, set the soft key to ON
To run or test the program with the NC blocks
preceded by a slash, set the soft key to OFF
This function does not work for TOOL DEF blocks.
After a power interruption the TNC returns to the
most recently selected setting.
Inserting the "/" character
In the Programming mode you select the block in which the
character is to be added
Press the INSERT soft key
Erasing the "/" character
In the Programming mode you select the block in which the
character is to be erased
Press the REMOVE soft key
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016
Optional block skip 15.7
15
575