HEIDENHAIN TNC 320 User Manual page 296

8
Subprograms and program section repeats
8.1 Labeling subprograms and program section repeats
8.1 Labeling subprograms and program
section repeats
Subprograms and program section repeats enable you to program a
machining sequence once and then run it as often as necessary.
Label
The beginnings of subprograms and program section repeats are
marked in a part program by labels (LBL).
A LABEL is identified by a number between 1 and 65535 or by a
name you define. Each LABEL number or LABEL name can be set
only once in the program with the LABEL SET key. The number of
label names you can enter is only limited by the internal memory.
Do not use a label number or label name more than
once!
Label 0 (LBL 0) is used exclusively to mark the end of a
subprogram and can therefore be used as often as desired.
296
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016