The Tool Table Tool.t - HEIDENHAIN TNC 320 User Manual

Compact contouring control

Hide thumbs Also See for TNC 320:

Table of Contents

First Steps with the TNC 320

Setting up tools

The tool table TOOL.T

In the tool table TOOL.T (permanently saved under TNC:\table\),

save the tool data such as length and radius, but also further tool-

specific information that the TNC needs to perform its functions.

To enter tool data in the tool table TOOL.T, proceed as follows:

Display the tool table: The TNC shows the tool

Edit the tool table: Set the EDIT soft key to ON

With the upward or downward arrow keys you can

select the tool number that you want to edit

With the rightward or leftward arrow keys you can

select the tool data that you want to edit

To exit the tool table, press the END key

Further information on this topic

Operating modes of the TNC

Further Information:

Working with the tool table

Further Information:

"Modes of operation", page 77

"Enter tool data into the table",

HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016