Program Run, Full Sequence and Program Run,
Single Block
In the Program run full sequence mode, the TNC executes a
program continuously to its end or to a manual or programmed
stop. You can resume program run after an interruption.
In the Program run single block mode, you execute each block
separately by pressing the NC START key. With point pattern cycles
and CYCL CALL PAT the controls stops after each point.
Soft keys for selecting the screen layout
Soft key
Window
Program
Left: program, right: structure
Left: program, right: status display
Left: program, right: graphics
Graphic
Left: program, right: collision object
Collision body
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016
Modes of operation
2
2.3
79