HEIDENHAIN TNC 320 User Manual page 306

8
Subprograms and program section repeats
8.5 Nesting
Subprogram within a subprogram
Example NC blocks
0 BEGIN PGM UPGMS MM
...
17 CALL LBL "UP1"
...
35 L Z+100 R0 FMAX M2
36 LBL "UP1"
...
39 CALL LBL 2
...
45 LBL 0
46 LBL 2
...
62 LBL 0
63 END PGM SUBPGMS MM
Program execution
1 Main program UPGMS is executed up to block 17 .
2 Subprogram SP1 is called, and executed up to block 39.
3 Subprogram 2 is called, and executed up to block 62. End of
subprogram 2 and return jump to the subprogram from which it
was called.
4 Subprogram 1 is called, and executed from block 40 up to block
45. End of subprogram 1 and return jump to the main program
UPGMS.
5 Main program UPGMS is executed from block 18 up to block 35.
Return jump to block 1 and end of program.
306
Call the subprogram marked with LBL SP1
Last program block of the main program with M2
Beginning of subprogram SP1
Call the subprogram marked with LBL 2
End of subprogram 1
Beginning of subprogram 2
End of subprogram 2
HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016