HEIDENHAIN TNC 320 User Manual page 541

Compact contouring control

Hide thumbs Also See for TNC 320:

Table of Contents

Programming and executing simple machining operations 14.1

Protecting programs in $MDI

The $MDI file is intended for short programs that are only needed

temporarily. Nevertheless, you can store a program, if necessary,

by proceeding as described below:

Operating mode: Press the Programming key

To call the file manager, press the PGM MGT key.

Move the highlight to the $MDI file

To copy the file: Press the COPY soft key

DESTINATION FILE =

Enter the name under which you want to save the current

contents of the $MDI file, e.g.HOLE

Press the OK soft key.

To exit the file manager, press the END soft key

Further Information:

"Copying a single file", page 137

HEIDENHAIN | TNC 320 | Conversational Programming User's Manual | 9/2016