Siemens siprotec SJ62 User Manual page 6

Definition
Typographic and
Graphical Conven-
tions
SIPROTEC 4, 7SJ62/63/64 Handbuch
C53000-G1140-C147-A, Edition 07.2015
WARNING!
When operating an electrical device, certain parts of the device inevitably have dan-
gerous voltages.
Failure to observe these precautions can result in fatality, personal injury, or extensive
material damage.
Only qualified personnel shall work on and around this equipment. It must be thor-
oughly familiar with all warnings and safety notices of this manual as well as with the
applicable safety regulations.
The successful and safe operation of this device is dependent on proper handling, in-
stallation, operation, and maintenance by qualified personnel under observance of all
warnings and hints contained in this manual. In particular the general erection and
safety regulations (e.g. IEC, DIN, VDE, EN or other national and international stan-
dards) regarding the correct use of hoisting gear must be observed.
QUALIFIED PERSONNEL
For the purpose of this instruction manual and product labels, a qualified person is
one who is familiar with the installation, construction and operation of the equipment
and the hazards involved. In addition, he has the following qualifications:
• Is trained and authorized to energize, de-energize, clear, ground and tag circuits
and equipment in accordance with established safety practices.
• Is trained in the proper care and use of protective equipment in accordance with
established safety practices.
• Is trained in rendering first aid.
To designate terms which refer in the text to information of the device or for the
device, the following fonts are used:
Parameter names
Designators of configuration or function parameters which may appear word-for-
word in the display of the device or on the screen of a personal computer (with op-
eration software DIGSI), are marked in bold letters of a monospace type style. This
also applies to header bars for selection menus.
1234A
Parameter addresses have the same character style as parameter names. Param-
eter addresses contain the suffix A in the overview tables if the parameter can only
be set in DIGSI via the option Display additional settings.
Parameter Conditions
possible settings of text parameters, which may appear word-for-word in the display
of the device or on the screen of a personal computer (with operation software
DIGSI), are additionally written in italics. This also applies to header bars for selec-
tion menus.
„Annunciations"
Designators for information, which may be output by the relay or required from other
devices or from the switch gear, are marked in a monospace type style in quotation
marks.
Deviations may be permitted in drawings and tables when the type of designator can
be obviously derived from the illustration.
Preface
6