Siemens siprotec SJ62 User Manual page 398

Pickup Voltages of
BI6 to BI7
Bus Address
SIPROTEC 4, 7SJ62/63/64 Handbuch
C53000-G1140-C147-A, Edition 07.2015
the input I and may thus have a setting that deviates from that of the phase currents.
N
In models with sensitive ground fault current input there is no jumper X64.
For normal ground current inputs the jumper X65 is plugged in position „IE" and for
sensitive ground current inputs in position „IEE".
Table 3-24 Jumper settings for Pickup Voltages of the binary inputs BI6 and BI7 on the in-
put/output board C-I/O-11
Binary Input Jumper
BI6
BI7
1)
Factory settings for devices with power supply voltages of 24 VDC to 125 VDC
2)
Factory settings for devices with power supply voltages of 110 to 250 VDC and 115 VAC or
115 to 230 VAC
3)
Use only with pickup voltages 220 or 250 VDC
Jumpers X71, X72 and X73 on the input/output board C-I/O-11 are used to set the bus
address and must not be changed. The following table lists the jumper presettings.
Mounting location:
1
with housing size /
3
1
with housing size /
2
1
with housing size /
1
Table 3-25 Jumper Settings of Bus Addresses of Input/Output Board C–I/O-11 for 7SJ64
Jumper Presetting
X71
X72
X73
19 VDC Pickup
X21 L
X22 L
Serial no. 2 in Figure 3-6, slot 19
Serial no. 2 in Figure 3-7, slot 33
Serial no. 2 in Figure 3-8, slot 33 on right side
1-2 (H)
1-2 (H)
2-3 (L)
3.1 Mounting and Connections
1)
88 VDC Pickup 176 VDC Pickup
2)
M
M
3)
H
H
396