Settings Groups; Description; Setting Notes - Siemens siprotec SJ62 User Manual

2.1.5

Settings Groups

Applications
2.1.5.1

Description

Changing Setting
Groups
2.1.5.2

Setting Notes

General
SIPROTEC 4, 7SJ62/63/64 Handbuch
C53000-G1140-C147-A, Edition 07.2015
Four independent setting groups can be created for establishing the device's function
settings.
• Setting groups enables the user to save the corresponding settings for each appli-
cation so that they can be quickly called when required. All setting groups are stored
in the relay. Only one setting group may be active at a given time.
During operation the user can switch back and fourth between setting groups locally,
via the operator panel, binary inputs (if so configured), the service interface using a
personal computer, or via the system interface. For reasons of safety it is not possible
to change between setting groups during a power system fault.
A setting group includes the setting values for all functions that have been selected as
Enabled during configuration (see Section 2.1.1.2). In 7SJ62/63/64 devices, four in-
dependent setting groups (A to D) are available. Whereas setting values may vary, the
selected functions of each setting group remain the same.
If multiple setting groups are not required, group A is the default selection. Then, the
rest of this section is not applicable.
If multiple setting groups are desired, address Grp Chge OPTION must be set to
Enabled (address 103). For the setting of the function parameters, you configure
each of the required setting groups A to D, one after the other. A maximum of 4 is pos-
sible. Please refer to the SIPROTEC 4 System Description, to learn how to copy
setting groups or reset them to their status at delivery and also what you have to do to
change from one setting group to another.
Subsection 3.1 of this manual tells you how to change between several setting groups
externally via binary inputs.
2.1 General
52