Siemens siprotec SJ62 User Manual page 532

Profibus FMS Slave, electrical RS485
Profibus FMS Slave, optical, Single Ring, ST-Connector
Profibus FMS Slave, optical, Double Ring, ST-Connector
For further interface options see Additional Information in the following
Additional information to further system interfaces (device rear, port B)
Profibus DP Slave, RS485
Profibus DP Slave, 820 nm, optical Double Ring, ST–Connector
Modbus RS485
Modbus, 820 nm, optical, ST–Connector
DNP3.0, RS485
DNP3.0, 820 nm, optical, ST–Connector
IEC 61850, Ethernet electrical (EN 100)
IEC 61850, Ethernet optical, double, LC-connector (EN 100)
No DIGSI interface at the back
DIGSI/Modem, electrical RS232
DIGSI/Modem/RTD box
DIGSI/Modem/RTD box
With fault recording
With fault recording, average values, min/max values
SIPROTEC 4, 7SJ62/63/64 Handbuch
C53000-G1140-C147-A, Edition 07.2015
System Interface (Rear Side, Port B)
2)
2)
3)
,
1)
Cannot be delivered in connection with 9th digit = "B". If the optical interface is required you
must order the following: 11th digit = 4 (RS485) and in addition, the associated converter
2)
Cannot be delivered in connection with 9th digit = "B".
3)
In the surface mounting case with 2 tier terminals as of January 2005
4)
Deliverable as of April 2005
Converter
1)
SIEMENS OLM
1)
SIEMENS OLM
1)
The converter requires an operating voltage of 24 VDC. If the available operating voltage is
> 24 VDC the additional power supply 7XV5810–0BA00 is required.
DIGSI/Modem Interface (Rear Side, Port C)
1)
, electrical RS485
1)
, optical 820 nm, ST connector
1)
RTD-box 7XV5662–*AD10
2)
If you want to run the RTD-Box at an optical interface, you need also the RS485–FO–con-
verter 7XV5650–0*A00.
Measuring/Fault Recording
A.1 Ordering Information and Accessories
1)
1)
1)
2) 4)
,
Order No.
6GK1502–2CB10
6GK1502–3CB10
2)
Pos. 11
4
1)
5
1)
6
9
Supple-
mentary
+ L 0 A
1)
+ L 0 B
+ L 0 D
2)
+ L 0 E
+ L 0 G
2)
+ L 0 H
3)
+ L 0 R,
2) 4)
+ L 0 S ,
Use
For single ring
For double ring
Pos. 12
0
1
2
3
Pos. 13
1
3
530