Configuring Ipv6 Vrrp; Ipv6 Vrrp Configuration Task List; Specifying An Ipv6 Vrrp Operating Mode - HP MSR Series Configuration Manual

Task
Display statistics for IPv4 VRRP
groups.
Clear statistics for IPv4 VRRP
groups.

Configuring IPv6 VRRP

This section describes how to configure IPv6 VRRP.

IPv6 VRRP configuration task list

Tasks at a glance
(Required.) Specifying an IPv6 VRRP operating
mode
(Required.) Creating a VRRP group and assigning
a virtual IPv6 address
(Optional.) Configuring the router priority,
preemptive mode, and tracking function
(Optional.) Specifying an IPv6 VRRP control
VLAN
(Optional.) Configuring VF tracking
(Optional.) Configuring IPv6 VRRP packet
attributes
(Optional.) Disabling an IPv6 VRRP group

Specifying an IPv6 VRRP operating mode

A VRRP group can operate in either of the following modes:
• Standard mode—Only the master can forward packets.
Load balancing mode—All members that have an AVF can forward packets.
•
After the IPv6 VRRP operating mode is specified on a router, all IPv6 VRRP groups on the router operate
in the specified operating mode.
To specify an IPv6 VRRP operating mode:
Step
1. Enter system view.
2. Specify an IPv6 VRRP
operating mode.
Command
display vrrp statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
reset vrrp statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
Remarks
N/A
N/A
N/A
This configuration does not apply to VRRP load balancing
mode.
This configuration applies only to VRRP load balancing mode.
N/A
N/A
Command
system-view
•
Specify the standard mode:
undo vrrp ipv6 mode
•
Specify the load balancing mode:
vrrp ipv6 mode load-balance
29
Remarks
N/A
By default, VRRP operates in standard
mode.