Mld Proxying Configuration Example - HP MSR ASM Configuration Manual

# Display information about the IPv6 multicast groups created based on the configured MLD SSM
mappings on Router D.
[RouterD] display mld ssm-mapping group
Total 1 MLD SSM-mapping Group(s).
Interface group report information
Ethernet1/1(4001::2):
Total 1 MLD SSM-mapping Group reported
Group Address: FF3E::101
Last Reporter: 4001::1
Uptime: 00:02:04
Expires: off
# Display IPv6 PIM routing table information on Router D.
[RouterD] display pim ipv6 routing-table
Total 0 (*, G) entry; 2 (S, G) entry
(1001::1, FF3E::101)
Protocol: pim-ssm, Flag:
UpTime: 00:13:25
Upstream interface: Ethernet1/3
Upstream neighbor: 1003::1
RPF prime neighbor: 1003::1
Downstream interface(s) information:
Total number of downstreams: 1
1: Ethernet1/1
(3001::1, FF3E::101)
Protocol: pim-ssm, Flag:
UpTime: 00:13:25
Upstream interface: Ethernet1/2
Upstream neighbor: 3002::1
RPF prime neighbor: 3002::1
Downstream interface(s) information:
Total number of downstreams: 1
1: Ethernet1/1

MLD proxying configuration example

Network requirements
As shown in
receive VOD information sent to multicast group FF3E::101.
Configure the MLD proxying feature on Router B so that Router B can maintain group memberships and
forward IPv6 multicast traffic without running IPv6 PIM-DM.
Protocol: mld, UpTime: 00:13:25, Expires: -
Protocol: mld, UpTime: 00:13:25, Expires: -
Figure 81, IPv6 PIM-DM runs on the core network. Host A and Host C in the stub network
292