Mld Proxying Configuration Example - HP A8800 Configuration Manual

UpTime: 00:13:25
Upstream interface: GigabitEthernet3/1/2
Upstream neighbor: 3002::1
RPF prime neighbor: 3002::1
Downstream interface(s) information:
Total number of downstreams: 1
1: GigabitEthernet3/1/1

MLD proxying configuration example

Network requirements
As shown in
receive VOD information sent to multicast group FF3E::101.
Configure the MLD proxying feature on Router B so that Router B can maintain group memberships and
forward IPv6 multicast traffic without running IPv6 PIM-DM.
Figure 101 Network diagram
Proxy & Querier
Router B
GE3/1/2
3001::1/64
Receiver
Host A
Configuration procedure
1. Enable IPv6 forwarding on each router and assign the IPv6 address and prefix length to each
interface as per
2. Enable IPv6 multicast routing, IPv6 PIM-DM, MLD, and MLD proxying respectively:
# On Router A, enable IPv6 multicast routing globally, enable IPv6 PIM-DM on Serial 4/1/9/1:0,
and enable MLD on GigabitEthernet 3/1/1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface Serial 4/1/9/1:0
[RouterA-Serial4/1/9/1:0] pim ipv6 dm
[RouterA-Serial4/1/9/1:0] quit
[RouterA] interface GigabitEthernet 3/1/1
[RouterA-GigabitEthernet3/1/1] mld enable
[RouterA-GigabitEthernet3/1/1] pim ipv6 dm
[RouterA-GigabitEthernet3/1/1] quit
Protocol: mld, UpTime: 00:13:25, Expires: -
Figure 101, IPv6 PIM-DM runs on the core network. Host A and Host C in the stub network
Querier
Router A
GE3/1/1
2001::1/64
GE3/1/1
2001::2/64
Host B
Figure 101. (Details not shown.)
IPv6 PIM-DM
S4/1/9/1:0
1001::1/64
Receiver
Host C
370