Sa Message Filtering Configuration - HP A8800 Configuration Manual

RPF prime neighbor: 10.110.4.2
Downstream interface(s) information:
Total number of downstreams: 1
1: GigabitEthernet3/1/1

SA message filtering configuration

Network requirements
There are three PIM-SM domains, with OSPF running within each domain and among these domains to
provide unicast routes.
Loopback 0 of Router A, Router C, and Router D are configured as a C-BSR and a C-RP of the PIM-SM
domains respectively.
Set up MSDP peering relationships between Router A and Router C and between Router C and Router D.
Multicast source Source 1 sends multicast data to multicast groups 225.1.1.0/30 and 226.1.1.0/30;
Source 2 sends multicast data to 227.1.1.0/30.
Configure SA message filtering rules so that Host A and Host B can receive only the multicast data for
225.1.1.0/30 and 226.1.1.0/30, and Host C can receive only the multicast data for 226.1.1.0/30 and
227.1.1.0/30.
Figure 62 Network diagram
PIM-SM 1
Receiver
Host A
Source 1
Table 17 shows the interface and IP address assignment, and network topology scheme.
Table 17 Interface and IP address assignment
Device
Source 1
Source 2
Router A
Protocol: pim-sm, UpTime:
Loop0
GE3/1/1
Router A
S4/1/9/1:0
S4/1/9/1:0
GE3/1/1
Router B
MSDP peers
Interface
—
—
GigabitEthernet 3/1/1
- , Expires:
PIM-SM 2
Loop0
Router C
S4/1/9/1:0
GE3/1/1
Receiver
Host B
IP address
10.110.3.100/24
10.110.6.100/24
10.110.1.1/24
214
-
PIM-SM 3
Source 2
GE3/1/1
S4/1/9/1:0
Router D
GE3/1/2
Receiver
Host C