Configuring
C hapter 5
To generate energy pulses through a relay output:
Configuring Analog Outputs
Using PAS
EM13x Series SMART MULTIFUNCTION METER
the EM13X Series
Generating Energy Pulses through Relay Outputs
Set a relay to either pulse, or KYZ mode, and then select a polarity
(active pulse edge) for energy pulses and a pulse width.
Select a source energy accumulator and the pulse rate for your output
Send your new setup to the meter
The meter can be ordered with four optional analog outputs with
options for 0-1mA, ±1mA, 0-20mA and 4-20mA current outputs.
Select General Setup from the Meter Setup menu, and then click on
the Analog Outputs tab.
Figure 5 -10: General Setup Dialog Box – Analog Outputs Tab
General Meter Setup
89