Configuring Relay Outputs - Satec EM132 Installation And Operation Manual

‎ C hapter 5
Configuring the EM13X Series

Configuring Relay Outputs

Using PAS
86
Table 11: Digital Inputs Options
Parameter
T
Input Polarity h NORMAL
INVERTING
e
d
e
Pulse Input PULSE MODE
b
Mode KYZ MODE
o
u
n
c
e
Pulse Polarity NORMAL (N.O.),
INVERTING (N.C.)
t
i
m
e
Debounce 1-100 ms
i
Time
s
a
p
a
The debounce time is applied the same for all digital inputs. If you
change the debounce time for a digital input, the same debounce time
is automatically assigned to the others.
The PM130 PLUS can be provided with one relay (standard) and 2 or 4
optional relay outputs. Each relay can be operated either locally from
the alarm/control setpoints in response to an event or by a remote
command sent through communications. It can also be linked to an
internal pulse source to produce energy pulses.
Select General Setup from the Meter Setup menu, and then click on
the Relay Outputs tab.
Options Default
NORMAL For the normal polarity, the open
PULSE
MODE
NORMAL For the normal polarity, the open
10 ms
EM13x Series SMART MULTIFUNCTION METER
General Meter Setup
Description
to closed transition is considered
closed. For the inverting polarity,
the closed to open transition is
considered a closed
In pulse mode, either leading, or
trailing edge of the input pulse is
recognized as an event. In KYZ
mode, both leading and trailing
edges of the input pulse are
recognized as separate events.
to closed transition is considered
a pulse. For the inverting polarity,
the closed to open transition is
considered a pulse.
It has no meaning in KYZ mode
where both transitions are used.
The amount of time while the
state of the digital input should
not change to be recognized as a
new state. Too low debounce time
could produce multiple events on
the input change.