Setting Up Tcp Notification Client - Satec EM132 Installation And Operation Manual

Configuring
‎ C hapter 5
Table 6: eXpertPower Client Setup Options
XPW Server IP Address
XPWServerPort
XPW Client Enabled
Time to Next Session,
min

Setting Up TCP Notification Client

EM13x Series SMART MULTIFUNCTION METER
the EM13X Series
Figure ‎ 5 -4: eXpertPower Client Setup Tab
The following table lists available options. Refer to your eXpertPower
service provider for the correct network settings.
Parameter
0-65535
NO, YES
1-99999
NOTES
 Do not enable the eXpertPower client in your meter if you do not use the
TM
eXpertPower service.
 Do not change the connection time setting. It is for information only. The
eXpertPower server updates it automatically.
The TCP notification client can establish connections with a remote
Modbus/TCP server and send notification messages either on events,
or periodically on a time basis.
To set up communications with a remote TCP Notification server, select
Communication Setup from the Meter Setup menu, and then click
on the TCP Notification Client Setup tab.
Figure ‎ 5 -5: TCP Notification Client Setup Tab
The following table lists available client options.
Options Default
207.232.60.18
5001
NO
Configuring Communications
Description
The IP address of the
eXpertPower server
The TCP service port of the
eXpertPower server
Enables operations of the
eXpertPower client
The time remaining to the
next connection session
79