Analog Output Setup Menu - Satec C191HM Installation And Operation Manual

4.4 Analog Output Setup Menu

[This section is relevant to instruments ordered with this option.]
CHG
SELECT
This menu allows you to set up an output value and its zero and full scales for
the internal analog output. Table 4-3 explains the analog output setup options,
and Table 4-4 lists all measurement parameters that can be directed to analog
output.
Output parameter
Aout
Outp
rt U1
To view the setup options for the analog output:
SELECT
Press
Use the up/down arrow keys to scroll to the desired option. The value
associated with this option is displayed in the lower window.
To change the setup options for the selected channel:
Press
SELECT
Use the up/down arrow keys to scroll to the desired value.
Press
ENTER
unchanged.
Press ENTER
To quit the setup without changes:
From the middle or lower window, press
To quit the menu:
From the upper window, press
NOTES
1.
Except for the signed power factor, the output scale is linear within the value range.
The scale range will be inverted if the full scale specified is less than the zero scale.
The output scale for the signed power factor is symmetrical with regard to ±1.000 and
2.
is linear from -0 to -1.000, and from 1.000 to +0 (note that -1.000 ≡ +1.000). Negative
power factor is output as [-1.000 minus measured value], and non-negative power
factor is output as [+1.000 minus measured value]. To define the entire range for
power factor from -0 to +0, the scales would be specified as -0.000/0.000.
3.
Each time you select the output parameter for the analog channel, its zero and full
scales are set by default to the lower and upper parameter limits, respectively.
24
ENTER
Zero-scale output
Aout
Lo
0
to activate the middle window.
to activate the lower window.
to store the selected value, or press
again to store the setup for the channel.
or
ESC
Aout
Full-scale output
Aout
Hi
828
to leave the value
ESC
ESC .
.
ENTER
Chapter 4 Setup Menus
ENTER