Satec EM132 Installation And Operation Manual page 107

Configuring
‎ C hapter 5
To delete an existing file partition:
File
Event Log
Conventional data Log
Billing/TOU daily
profile log
No. File
1 Event log
2 Data log #1
17 Data log #16
EM13x Series SMART MULTIFUNCTION METER
the EM13X Series
To change the file properties or to create a new file:
 Double click on the file you want to change.
 Select desired parameters for your log.
 Click OK.
For your reference, the record size and the number of records available
for your file are reported in the dialog box.
 Click on Delete.
 Click OK.
NOTES
 Memory is allocated for a file statically when you set up your files and
will not change unless you re-organize files.
 The meter automatically performs de-fragmentation of the memory each
time you re-organize your files. This prevents possible leakage of
memory caused by fragmentation. It may take a couple of seconds.
For more information on configuring specific files, see the following
sections.
The following table can help you calculate an estimated file size when
planning your memory allocation.
Record Size, Bytes
16
12 + 4  Number of parameters
12 + 4  (Number of season tariffs + 1
for the TOU summary/total register)
The factory pre-set file configuration is shown in the following table.
Size, Channels
Bytes
3200
46080
8640 4
Record size  Number of records
Record size  Number of records
Record size  Number of billing registers
( 2 for the maximum demand profile) x
Number of records
Number of Number
Records of Events
200 200
5760 5760
90 90
Configuring Recorders
File Size, Bytes
Factory-set Configuration
200 last events
15-min data profile for 15 days
Daily billing/TOU profile for 90
days, 4 registers, totals + 3 tariffs
107