Chapter 6 Device Control And Upgrading; Resetting Accumulators, Maximum Values And Files - Satec EM132 Installation And Operation Manual

Device
‎ C hapter 6
Control and Upgrading
Chapter 6
Upgrading

6.1 Resetting Accumulators, Maximum Values and Files

Using the Front Display
To reset the desired values:
Using PAS
EM13x Series SMART MULTIFUNCTION METER
Device Control and
This section describes operations on the meter you can perform from
the front display or via PAS. To access device control options from PAS,
you should have your meter online.
Select the RESET entry from the main menu. See
Changing Setup Options
parameters via the front display.
Highlight the middle window by pressing briefly the SELECT button.
Select a reset entry by scrolling through the list with the UP and
DOWN arrow buttons.
Press the SELECT button briefly to highlight the lower item.
Press and hold the ENTER button for 5 seconds.
Release the button.
The do entry is replaced with done showing the operation is complete.
Table 21 shows the reset options available from the front display.
Table 21: Front Display Reset Options
Display Label
Power Dmd
V/A Dmd
Min/Max
Counters
Counter 1 – Counter 4
Diagnostics
Ensure that the On-line button on the PAS toolbar is checked, and
then select Reset from the Monitor menu.
Resetting Accumulators, Maximum Values and Files
in Chapter 3 for information on configuring
Description
Clears power maximum demands
Clears ampere and volt maximum demands
Clears Min/Max log
Clears all counters
Clears counter #1-#4
Clears device diagnostics
Viewing and
115