Satec EM132 Installation And Operation Manual page 7

To operate the EM13X Series:
Configuring the EM13X Series remotely
EM13x Series SMART MULTIFUNCTION METER
Assembling the 12DI/4RO module
 Perform device diagnostics.
 Configure the device through the EM13X Series unit front panel display
 Install the PAS application software on your PC.
 Configure the PAS database for your meter.
 Configure the PAS communications settings.
 Upgrade the meter firmware if a new version is available.
 Set up the meter using the PAS application software.
 Configure your security settings through the meter security setup.
 Configure your communication protocol settings.
 Configure Billing/TOU registers.
At this stage, the EM13X Series should be ready for operation.
7