Satec EM132 Installation And Operation Manual page 5

To mount the EM13X Series on flat surface:


Connecting the EM13X Series Unit








Common Wiring Mode: EM13x and EM13x-SE 4LL3 or 4Ln3
EM13x Series SMART MULTIFUNCTION METER
Locate the EM13X Series on the surface to
Push up the DIN rail brackets to lock the EM13X Series on the rail.
Ensure that all incoming power sources are OFF.
Check that you have the appropriate power supply.
For direct connection, connect to CT wires through the meter CT
terminals. Observe the arrow that indicates the current direction.
In case of a retrofit application or high current external SATEC CT (or
Split Core) where each external CT ends with two wires:
Connect the wire to the meter current termination
screws.
Connect the measured voltage inputs
Connect COM1 – RS-485 communication port
In case of EM132/133 model with Aux. Power supply connect the Power
Supply inputs using 1.5 mm
EM13x-SE: Self Energized Meter model
2
/14AWG-dedicated wires.
5