Chapter 5 Configuring The Em13X Series; Configuring Communications; Setting Up Serial Communication Ports - Satec EM132 Installation And Operation Manual

‎ C hapter 5
Configuring the EM13X Series
Chapter 5
Series

5.1 Configuring Communications

Setting Up Serial Communication Ports

COM1 Protocol
Modbus RTU
74
Configuring the EM13X
This chapter describes how to configure the EM13X Series for your
particular environment and application from the front display and via
PAS. To access your meter configuration options via PAS, you should
create a site database for your device as shown in Chapter 4.
Using the Front Display
Select COM1 through COM3 from the main menu. See
Changing Setup Options
menus.
See the table below for available communication options.
Using PAS
Select Communications Setup from the Meter Setup menu, and then
click on the Serial Ports Setup tab. In the Port box, select the desired
device port.
Figure ‎ 5 -1: Communication Setup Dialog Box – Serial Ports Setup Tab
in Chapter 3 for information on navigating in
EM13x Series SMART MULTIFUNCTION METER
Configuring Communications
Viewing and