Integrating With Security Systems - HySecurity StrongArmPark DC Programming And Operations Manual

I
ntegratIng WItH
HySecurity gate operators provide a 2-wire, serial interface (RS-485 connection) which allows remote access to
one or more operators. With software protocols provided by
HySecurity, bi-directional status updates and control
commands are easily integrated with a central controller
(computer or server), which becomes the primary (master) to
the connected operators. Several physical operators (1 to 99)
can be polled from the central master command station.
Reset requests, gate control, gate status, and gate faults can
be monitored and information can be retrieved from the
central command station.
The RS-485 interface is also used to communicate with
the HyNet Gateway, a web-enabled interface. For specific
information regarding HyNet Gateway SFP 4/1, go to
www.hysecurity.com.
Smart DC Controller
COM
COM
COM
COM
COMMON
COM
TERMINALS
COM
COM
COM
STOP
OPEN
CLOSE
OPEN
P ARTIAL
SENSOR 2
SENSOR 3
EXIT
LOOP
BLOCK
EXIT
IN OBS
LOOP
OUT OBS
LOOP
CENTER
LOOP
SENSOR 1
SENSOR
COM
+ 24 V
EMERG
OPEN
SHOW
LEDs
www.hysecurity.com © 2017
s
eCurItY
HyNet
Flying lead connects to +24V
s
Ystems
OPEN
PREV
RS-485
Connector
Wire harness
RS-485
Ports
SDC Inputs & Wiring
SA 0 (OFF)
STC ADDRESS
CLOSE MENU
STOP
NEXT SELECT
SA Display in the Installer Menu
When the physical connection is
made and protocols are established,
an SA (System Address) must be
assigned for each operator through
its Installer Menu. For network
communication, choosing a SA of 1
to 99 establishes individual network
polling addresses. An SA of zero
means no network communication is
desired.
If you plan to connect operators to a
networked central master command
station, contact HySecurity for
software protocols and additional
information. Refer to Contact
Information on page 1.
MX3650-01 Rev. D
RESET
35