Drive Belt Tension And Alignment - HySecurity StrongArmPark DC Programming And Operations Manual

d B t
rIve elt
Proper drive belt tension is important for prolonging the life of the drive belt and maintaining the superior
performance of the operator. To check the drive belt tension, take the following steps:
1. Remove the Front Access Panel.
2. Turn off the AC and DC power switches.
3. Remove the StrongArmPark DC top cover and drive belt cover.
4. Check to make sure the pulleys are aligned vertically.
5. With your finger, apply light outward pressure
to the drive belt. If it is properly tensioned, it
should only move about Z\zn to Z\,-inch (1.6 to
3.2 cm).
6. To replace or re-tension the drive belt. Loosen
the four motor bracket nuts and move the
motor accordingly.
7. Retighten the motor bracket nuts.
8. Replace the drive belt cover and top cover.
9. Turn the AC and DC power switches ON. This
cycles power which allows the operator to
search for the target magnet and "relearn"
its limits.
NOTE: Be aware that the arm will cycle open, and then
close, as it relearns its limits. If you don't cycle the power,
the operator will not "relearn" its limits and will not operate properly.
74
MX3650-01 Rev. D
ensIon and
StrongArmPark DC Programming & Operations
a
lIgnment
DC and AC
power switches
Front access panel
LTR
Pulley
Top cover
Drive belt
cover
Z\zn to Z\,-inches
(1.6 to 3.2 mm)
Motor bracket nuts
© 2017 www.hysecurity.com