Integrating With Security Systems And Hynet™ Gateway - HySecurity StrongArm 14F Programming And Operations Manual

i
nteGratinG With
HySecurity hydraulic gate operators provides a 2-wire, serial interface (RS-485 connection) which allows remote
access to one or more operators. With software protocols provided by HySecurity, bi-directional status updates
and control commands are easily integrated with a central controller (computer or server), which becomes the
primary (master) to the connected operators. Up to 31 physical operators can be polled from the central
master command station. Reset requests, gate control, gate status, and gate faults can be monitored and
information can be retrieved from the central command station.
The RS-485 interface is also used to communicate with the HyNet Gateway, a web-enabled interface. To view
the user guide and quick start information regarding HyNet Gateway SFP 4/1, go to the HySecurity website,
Technical_Support_Installation_Manuals.
Power Supply
Board
+24VDC
NOTE: Connect HyNet power
to +24VDC on the Power Supply
Board. Do NOT connect HyNet
to +24V terminal under RADIO
OPTIONS.
MX3657-01 Rev. D ©2020
s s
eCurity ysteMs and
Power Connector
DRIVE POWER
1
STOP BUTTON
2
OPEN BUTTON
3
CLOSE BUTTON
REMOTE OPEN AND
4
RADIO CONTROL
5
OPEN/CLOSE
6
OPEN PARTIAL
INTERLOCK OPEN
7
TIME CLOCK OPEN
8
FREE EXIT DETECTOR
DISABLE EXIT DETECTOR
9
DISABLE CLOSE TIMER
10 INSIDE OBSTRUCTION
VEHICLE DETECTOR
OUTSIDE OBSTRUCTION
11
VEHICLE DETECTOR
SHADOW/RESET
12
VEHICLE DETECTOR
SENSOR 1
14
SENSOR
COM
15
16 DO NOT USE
17
SENSOR 2
18
DO NOT USE
19
SENSOR 3
20
DO NOT USE
CHARGER
21
AC LOSS
HySecurity
22
LOCK INTERLOCK
MX000585
VERSION
23
S/N
EMERG CLOSE
24
FIRE DEPT OPEN
Smart Touch Controller
LED
LIMIT DUAL GATE RADIO OPTIONS
RPM
COM A B COM OPEN +24V +24V
Smart Touch Controller
Once the physical connection is made and protocols are
established, an SA (System Address) must be assigned
for each operator through its Installer Menu. For network
communication, choosing a "SA" of 1 to 99 establishes
individual network polling addresses. A "SA" of zero
means no network communication is desired.
If you plan to connect operators to a networked central
master command station, contact HySecurity for software
protocols and additional information. Refer to Contact
Information on page 2.
STC Inputs & Wiring
h
y
RS485
COM
NO
STATUS
SA Display in the Installer Menu
S 1
COM
hysecurity.com | 800-321-9947
n ™ G
et ateWay
SA 1
SYSTEM ADDRESS
77