Display & Menu Options; Initial Setup; Understanding The Display And Keypad - HySecurity StrongArmPark DC Programming And Operations Manual

Highly sophisticated software provides three different modes of operation: run, program, and fault.
How to navigate using the Smart DC Controller (SDC) keypad, interpret status display codes and program the
operator is found in this section.
I s
nItIal etup
Once you have completed the installation, attached accessories and
turned power ON, you're ready to program the operator. Two different
approaches exist:
• Connect a laptop computer to the serial (RS-232 or USB) port,
check for the most current software version and then set the
operator menu configurations via the START software.
See Smart Touch Analyze and Retrieve Tool (S.T.A.R.T.) on page
71.
NOTE: Use a laptop computer at your place of business to conveniently download the free START software and
most current software version from www.hysecurity.com before heading out into the field. This makes
it easy to adjust settings using a laptop.
• Manually navigate through the User and Installer Menus using the SDC keypad. The instructions for
performing this second option are provided in this section.
u
nderstandIng tHe
The SDC display and keypad provide access to the operator's sophisticated software and functionality.
Three different operational modes exist:
• Run Mode - gate is operational, awaiting commands.
• Menu Mode - motor disengages and operator
commands are ignored. Data entry, menu navigation, and
menu selection can be accomplished via the keypad or
through a S.T.A.R.T. software connection using the RS-232
or USB port.
• Fault Mode - alerts, faults, or errors appear on the
display. Some errors or faults can be reset with the Reset
button while more serious faults require additional
troubleshooting. Faults indicate a need for diagnosis and
resolution. Refer to Troubleshooting.
The keypad lets you navigate, change, or clear the information in the display menus. The singular use of these
keys is dependent on the operator mode.
The buttons with text above and below have two functions. Use these buttons to enter operating commands
or navigate through the User and Installer Menus.
www.hysecurity.com © 2017
Display & Menu Options
d
IsplaY and
Display & Menu Options
k
eYpad
HYSECURITY
GATE STOPPED
CLOSE
OPEN
NEXT
PREV
Display in Run Mode:
Stop, Open, or Close
MX3650-01 Rev. D
MENU
STOP RESET
SELECT
19