Photo Eye Alignment Feature; Smart Dc Controller: Menu Mode Navigation Buttons - HySecurity StrongArmPark DC Programming And Operations Manual

p e a
Hoto Ye
Most photo eyes require careful optical alignment in order to aim the emitter beam to the center of the
receiver or reflector. In order to avoid false triggering, it is important to carefully align the system.
Align the photo eyes using this feature by taking the following steps:
1. Access the User Menu and select PE.
To access the User Menu, press the Menu button twice. For a
refresher on using the Menu Mode navigational buttons, refer to the
chart below.
2. Press NEXT and continue to press NEXT until PE 0 (OFF) appears.
3. Press SELECT.
PE characters begin blinking.
4. To turn ON photo eye alignment and temporarily power the sensors, press NEXT so PE 1 (ON) appears.
5. Press SELECT.
PE stops blinking.
6. Move the photo eyes (up/down, side to side) to align the emitter beam.
Audible Chirp
One
Two
7. When the buzzer chirps twice, indicating the photo eyes are aligned, set the next photo eye (if the site
has one) and continue the process until all photo eyes are aligned.
8. Press MENU to exit Menu Mode and return to Run Mode.
9. Move the gate with an open or close command. When a limit is triggered, the User Menu item PE
resets to zero (OFF).
To access To change menu item
Menu mode appearing in the display
Press the Menu button
twice. Two left characters blink.
www.hysecurity.com © 2017
f
lIgnment
Beam Aligned ??
No
Yes

Smart DC Controller: Menu Mode Navigation Buttons

To navigate through
the menu item selections
Press Next or Previous.
Press Select.
Continue pressing Next to view all
eature
To choose what item appears
selections.
Photo Eye Installation
PE 1 (ON)
PHOTO EYE ALIGN
OPEN CLOSE
PREV NEXT
on the display
Press Select.
Blinking characters
become static. Previous - press Previous
MX3650-01 Rev. D
STOP MENU RESET
SELECT
To navigate between
menu items
Press Next or Previous.
Advance - press Next
57