Wind Load Factors & Site Prep; Manual Release - HySecurity StrongArmPark DC Programming And Operations Manual

W l
Ind oad
Wind load is always a factor when considering the appropriate gate for a particular site. Solid gate panels
produce a larger wind load than gates with slats or open decorative features. If you are installing a gate
operator in high wind areas, the gate design may affect the load on the gate operator. Because wind force acts
the same as an obstruction, it is important that gates be designed to present a relatively low surface area for
the wind to push on the gate panel.
In the case of the StrongArmPark DC, it is always advisable to remove the barrier arm altogether when high
winds are anticipated. Another option is to install a catch post to keep the barrier arm from bending in the
wind.
NOTICE: Under certain wind load conditions, damage to the barrier arm or gate operator may occur and is not
covered by the HySecurity Warranty.
StrongArmPark DC incorporates a dynamic reversing sensor into its design. More information about adjusting
the sensitivity can be found in this manual under, Adjusting the Dynamic Reversing Sensor on page 66.
When the barrier arm encounters an impediment, it sends a signal to the gate operator to stop and reverse
direction. This feature may be falsely triggered in excessively windy conditions.
m r
anual elease
NOTICE: Before attempting a manual release, make sure the barrier arm is not in motion.
Make sure and instruct all users how to move the gate
manually. Use the Hold Open toggle switch to raise the
barrier arm or, in the case of complete AC & DC power
loss, turn off both AC and DC power switches and lift the
barrier arm to open it.
10
MX3650-01 Rev. D
f & s
aCtors
StrongArmPark DC Programming & Operations
p
Ite rep
DC switch On/Off
Switch, Hold Open/Close
AC switch On/Off
© 2017 www.hysecurity.com