Interface Address Configuration And Utilities - Edge-Core ES3528MV2 Management Manual

Interface Address Configuration and Utilities

ipv6
default-gateway
Table 197: IPv6 Configuration Commands (Continued)
Command Function
show ipv6 Displays the current IPv6 default gateway
default-gateway
show ipv6 interface Displays the usability and configured settings for IPv6
interfaces
show ipv6 mtu Displays maximum transmission unit (MTU)
information for IPv6 interfaces
show ipv6 traffic Displays statistics about IPv6 traffic
clear ipv6 traffic Resets IPv6 traffic counters
ping6 Sends IPv6 ICMP echo request packets to another
node on the network
traceroute6 Shows the route packets take to the specified host
Neighbor Discovery
ipv6 nd dad attempts Configures the number of consecutive neighbor
solicitation messages sent on an interface during
duplicate address detection
ipv6 nd ns-interval Configures the interval between IPv6 neighbor
solicitation retransmissions on an interface
ipv6 nd raguard Blocks incoming Router Advertisement and Router
Redirect packets
ipv6 nd reachable-time Configures the amount of time that a remote IPv6
node is considered reachable after some reachability
confirmation event has occurred
clear ipv6 neighbors Deletes all dynamic entries in the IPv6 neighbor
discovery cache
show ipv6 nd raguard Displays the configuration setting for RA Guard
show ipv6 neighbors Displays information in the IPv6 neighbor discovery
cache
This command sets an IPv6 default gateway to use when the destination is
located in a different network segment. Use the no form to remove a
previously configured default gateway.
S
YNTAX
ipv6 default-gateway ipv6-address
no ipv6 address
ipv6-address - The IPv6 address of the default next hop router to
use when the destination is located in a different network segment.
D S
EFAULT ETTING
No default gateway is defined
C M
OMMAND ODE
Global Configuration
– 1405 –
| IP Interface Commands
C 45
HAPTER
IPv6 Interface
Mode
NE, PE
NE, PE
NE, PE
NE, PE
PE
PE
PE
IC
IC
IC
IC
PE
PE
PE