Check connector: Green
49 H018 9A1
Test connector: Green (1 pin)
o o
DO
S E L F -D W G N O S IS C H E C K
M O N ITO R
S E LEC T
(Tj)
O O O
4 9 H0 I 8 9A I
MADE IN
TROUBLESHOOTING WITH SST 4 A
INSPECTION PROCEDURE
. Connect the SST to the check connector. (Green,
1
2. Set the select switch to position A.
the left side wheel housing.
49 H018 9A1
86U04A-011
3. Ground the test connector (Green, 1-pin) with a
jumper wire.
86U04A-012
4. Turn the ignition switch ON.
5. Verify that 88 flashes on the digital display and that
the buzzer sounds for three seconds after turn
. If 88 does not flash, check the main relay (Refer
6
to page 4A—87), power supply circuit, and check
E R
7. If 88 flashes and the buzzer sounds continuously
W
A
trol unit and perform steps 3 and 4 again.
_
. Note the code numbers and check for the causes
8
B
JAPAN
86U04A-013
AFTER-REPAIR PROCEDURE
. Cancel the memory of malfunctions by disconnect-
1
' ing the negative battery cable and depressing the
86U04A-014
6
-pin) and the negative battery terminal.
Note
The check connector is located at the rear of
Note
The test connector is located near the Self-
Diagnosis Checker check connector.
ing the ignition switch ON.
connector wiring.
for more than 20 seconds, replace the engine con
by referring to the check sequences shown on
pages from 4A—15 to 4A—24. Repair as
necessary.
Note
Cancel the code numbers by performing the
after-repair procedure after repairing.
brake pedal for at least five seconds; then recon
nect the negative battery cable.
4A-11