Note:
•
The device can play DTMF tones to the remote endpoint. For more information,
see Configuring DTMF Tones for Test Calls on page 1042.
•
Test calls are done on all SIP Interfaces.
69.7
Test Call Configuration Examples
Below are a few examples of test call configurations.
Single Test Call Scenario: This example describes the configuration of a simple test
call scenario that includes a single test call between a simulated test endpoint on the
device and a remote endpoint.
•
Test Call Rules table configuration:
♦
♦
♦
♦
♦
♦
♦
Alternatively, if you want to route the test call using the Tel-to-IP Routing table for the
Gateway application, configure the following:
•
Test Call Rules table configuration:
♦
♦
♦
♦
♦
•
Tel-to-IP Routing table configuration:
♦
♦
♦
Batch Test Call Scenario: This example describes the configuration of a batch test
call setup for scheduled and continuous call testing of multiple endpoints. The test call
is done between two AudioCodes devices - Device A and Device B - with simulated
test endpoints. This eliminates the need for phone users, who would otherwise need
User's Manual
Figure 69-6: Single Test Call Example
Endpoint URI: "101"
Called URI: "201"
Route By: Dest Address
Destination Address: "10.30.40.01"
SIP Interface: SIPInterface_0
Call Party: Caller
Test Mode: Once
Endpoint URI: 101@10.0.0.1
Route By: Tel-to-IP
SIP Interface: SIPInterface_0
Called URI: 201@10.30.40.1
Call Party: Caller
Destination Phone Prefix: 201 (i.e., the Called URI user-part)
Source Phone Prefix: 101 (i.e., the Endpoint URI user-part)
Destination IP Address: 10.30.40.1
1044
Mediant 800B Gateway & E-SBC
Document #: LTRT-10632